- Hem /
- Produkter /
- Mikrofoner /
- Livemikrofoner /
- Live kondensatormikrofoner /
- Kondensatormikrofon till instrument /
- Audio Technica /
- Audio Technica ATM350SL Microphone with Clip-On Mounting System
Audio Technica ATM350SL Microphone with Clip-On Mounting System
Allmänt
An accordion can be a fairly awkward instrument to amplify since every part moves and the sound comes from everywhere. A great solution is to simply mount a microphone onto the accordion and this is exactly what the Audio Technica ATM350SL condenser microphone pack has been designed for. An ATM350a microphone provides the foundation of the pack and registers with clarity and balance, even if the sound pressure is high. Using the included AT8491S system, the microphone can be mounted directly onto the accordion by either screwing it securely to the grille for permanent installation or, if you prefer to be able to remove the microphone as needed, simply use the included tape pads. These adhesive pads leave no residue or damage to the finish of your instrument.
Specifikationer
Produktfunktioner
- Bodypackanslutning UniPak/Hirose 4p
- Känslighet mikrofon -49
- Maximal SPL 150 dB - 159 dB
- Maximal frekvens 20 - 20,9 kHz
- Minimal frekvens 40 - 49 Hz
- Riktningskarakteristik kardioid
- Speciellt till Dragspel
Vikt och mått inkluderar förpackning
- Vikt (inkl. förpackning) 700 gr
- Mått (inkl. förpackning) 31,5 x 15,0 x 8,5 cm
Produktspecifikationer
- Audio Technica ATM350SL
- accordion microphone
- capsule: condenser (permanently polarized)
- pickup pattern: cardioid
- frequency response: 40 - 20,000 Hz
- high-pass filter: 80 Hz, 12 dB
- sensitivity: -49 dB (3.5 mV) 1V at 1 Pa
- impedance: 200 Ohms
- max. sound pressure level (SPL): 159 dB, 1 kHz at 1% THV
- dynamic range: 130 dB, 1 kHz at max. SPL
- signal-to-noise ratio: 65 dB, 1 kHz at 1 Pa
- phantom power supply: 11 - 52V DC / 3.5 mA
- switch: neutral, roll-off
- microphone weight: 14.5 g
- power module weight: 90 g
- microphone dimensions: 37.8 mm (length)
- max. body diameter: 12.2 mm
- power module dimensions: 92 mm (length)
- 18.9 mm (diameter)
- output connector: 3-pin male XLRM
- cable:
- length: 4m (permanently fitted to microphone)
- diameter: 3.2 mm
- type: HIROSE HR10 (shielded)
- contents:
- ATM350a cardioid condenser microphone
- AT8543 power module
- AT8491S UniMount clip for accordion
- AT8490 UniMount 9-inch gooseneck
- AT8468 violin clip
- M36 protective carrying bag
Recensioner
Andra produkter från Audio Technica
Sök alla produkter från Audio Technica
Alternativa produkter från andra varumärken
Sök alla produkter i kategorin Kondensatormikrofon till instrument
